Possible Problems
If you find that your ST crashes during boot up or that you cannot properly use the cartridge plugged into the Forget-Me-Clock ll's pass-through connector, you should turn off your ST and check that the Forget-Me-Clock II and the other cartridge are firmly and squarely plugged into the ST and into each other.
If you find that despite having the Forget-Me-Clock II auto-run program automatically set the time at boot-up, the clock is always set to the default, then you should look to see if you are using an older version of the Control Panel desk accessory. Some older Control Panel versions set the time and date to a default setting and will not work with the Forget-Me-Clock II. See your dealer about getting a newer version of the Control Panel if you are having this problem.
If you have any problems which you cannot cure then please contact Frontier Software on England (0423) 567140/530577 or by Fax on (0423) 522874 or by writing to the address on Page 2 of this manual.
Post a comment